Abstract Considering the increasing adoption of Hybrid Plug-in and Electric Cars, there are concerns about recharging process of these vehicles considering the capacity of grid to provide sufficient energy to that purpose. In the past years, the growth of distributed energy generation from renewable and clean energy sources, especially photovoltaics, represents a possible and feasible solution to supply the energy used on recharging electric vehicles and reduction of greenhouse emission gases as CO2. This article is a study case that analyzes the energy production of a solar carport, located at Federal Technological University of Paraná (UTFPR) at Neoville Campus, comparing with energy consumption of a commercial electric car for a city use purpose. Based on solar energy generation, data from the web monitoring platform, real positioning characteristics of the solar carport installation, irradiation data collected from the National Institute of Meteorology basis and with a solarimetric station located at the same place as the solar carport is installed, the solar energy production is rated using three different metrics: yield, performance ratio and capacity factor. These metrics are calculated with RADIASOL2 software, a free and precise tool, developed by Federal University of Rio Grande do Sul (UFRGS) to execute computational simulation of photovoltaic systems using mathematical models. The results showed a slightly low energy production performance than expected, but more than enough energy to recharge an electric vehicle for a day use, demonstrating that a solar carport system could be a good solution to meet the energy demand for this application.

Abstract The photovoltaic solar energy has been growing in installed capacity worldwide year by year, and Brazil has also been investing in this renewable source of energy generation. The conversion of light into electrical energy occurs in the photovoltaic cells, which are sensitive to the increase of the temperature. A considerable amount of the energy incident on the module is transformed into heat, rising its temperature and decreasing its efficiency. This study aims to estimate the temperature in photovoltaic cells (Tc) for polycrystalline silicon modules from a grid-connected photovoltaic systems through several equations proposed over the last decades by researchers. This estimation will occur in the municipality of Curitiba, using data from INMET’s automatic station, located in the same city. The estimation was calculated hourly, throughout the day for one year. The validation of the estimated results was performed by measuring the cell temperature of a photovoltaic system installed in Curitiba, where it was observed that the equation proposed by Duffie and Beckman (2013) was the one that most approached to the measured value.

Abstract Understanding the solar radiation values in the surface is important for the development of solar energy projects, obtaining through radiometers installed in certain places or publications as in solar energy atlases. Typically, solar or weather stations do not have sensors to measure diffuse irradiation due to high investment and the need for constant maintenance. This paper presents methods for the determination of diffuse irradiation from surface measured data of global horizontal irradiation in the city of Curitiba, obtained through pyranometers installed at the Federal University of Technology – Paraná (UTFPR) headquarters and from Curitiba-A807 National Institute of Meteorology (INMET) station. Two models are presented for the estimation of the monthly mean daily diffuse irradiation, based on the studies of Liu and Jordan (1960) and Page (1961). Finally, these data were compared with those presented by the Solar Energy Atlas - Paraná, verifying the percentage differences presented. It was observed that the model elaborated by Page presented better results in the diffuse radiation estimates when compared to the values presented by the Paraná Atlas, with an average variation of -1.39% and -1.55%, for data from INMET and UTFPR respectively.

Abstract: Humanity is increasingly dependent on energy, which demand grows every year. Renewable energy sources are consolidated alternatives in the market, previously installed on a small scale but now thought as large plants. The correct operation, taking full advantage of the generation potential, depends on studies of the place of implantation, such as radiation levels, temperature, latitude, etc. Two photovoltaic systems installed in the city of Curitiba were studied in order to monitor their respective performances through figures of merit.

ABSTRACT This work presents the mapping of grid-connected photovoltaic systems supported by the Normative Resolution (NR) of the National Agency of Electric Energy (ANEEL) Nº 482/2012 in the city of Curitiba. Firstly, a brief introduction was made justifying the reasons that led to the development of this study, followed by the explanation about the methodology, procedures and criteria adopted in the study. A general mapping of all on-grid photovoltaic systems supported by NR Nº 482/2012 installed in the city of Curitiba, identified by class, is presented, indicating how the urban distribution of these photovoltaic systems occurs, and it is possible to observe in which regions the highest prevalence of installations occurs. From this, the general characterization of these photovoltaic systems is performed, classifying them by class, number of installed systems, power, number of modules, total occupied area, average power of modules and average efficiency of photovoltaic systems. Considerations are also raised regarding the reliability of the Database of Distributed Generation Consumer Units made available by ANEEL.

ABSTRACT Photovoltaic systems have been consolidated in the global energy scenario as an option of low environmental impact energy generation, high reliability and great applicability in urban centers, acting like energy generators near the point of consumption. The Federal University of Technology of Paraná (UTFPR), with the proposal of testing the performance of grid-connected photovoltaic systems (On Grid PV Systems) and help its entry into the Brazilian energy matrix, implemented this technology in two of its buildings: Green Office (GO) And Neoville. This paper analyzed the effects of dust on the Photovoltaic Systems performance based on daily energy. The analysis was carried out from the solar irradiance data from the places where the panels are installed and the electrical power data collected at the mass memory of the inverter of the two systems, in order to be analyzed and compared before and after the cleaning of the photovoltaic modules. The results at the end of the study indicate that dust directly impacts in the performance of the PV system.