Durante a cimentação de facetas cerâmicas, a polimerização de cimentos resinosos pode ser comprometida se a cerâmica atenuar a irradiância do aparelho fotopolimerizador. O objetivo deste estudo foi avaliar o efeito de diferentes tipos e espessuras de facetas cerâmicas sobre o grau de conversão de um cimento resinoso fotopolimerizável (RelyX Veneer). O cimento foi fotoativado após a interposição de facetas cerâmicas [IPS InLine, IPS Empress Esthetic, IPS e.max LT (baixa translucidez) e IPS e.max HT (alta translucidez) - Ivoclar Vivadent] de quatro espessuras (0,5 mm; 1,0 mm; 1,5 mm e 2,0 mm). Como controle, o cimento foi polimerizado sem interposição de cerâmica. O grau de conversão foi avaliado por espectroscopia FTIR (n=5). Os dados foram analisados através de ANOVA a um critério e teste de Tukey (α=0,05). Foram observadas diferenças significativas entre os grupos (p<0,001). O grau de conversão foi semelhante ao do controle para todos os grupos polimerizados com interposição de cerâmicas de 0,5 mm e 1,0 mm (p>0,05). Entre as facetas de 1,5 mm de espessura, IPS e.max LT foi a única que apresentou resultados diferentes do controle (p<0,05). Com a espessura de 2,0 mm, apenas IPS e.max LT e HT foram capazes de produzir cimentos com grau de conversão semelhantes aos do controle (p>0,05). O grau de conversão do cimento resinoso fotopolimerizável avaliado depende da espessura e do tipo de cerâmica utilizados quando facetas mais espessas do que 1,5 mm são cimentadas.
During the cementation of ceramic veneers the polymerization of resin cements may be jeopardized if the ceramics attenuate the irradiance of the light-curing device. The aim of this study was to evaluate the effect of different types and thicknesses of ceramic veneers on the degree of conversion of a light-cured resin-based cement (RelyX Veneer). The cement was light-cured after interposing ceramic veneers [IPS InLine, IPS Empress Esthetic, IPS e.max LT (low translucency) and IPS e.max HT (high translucency) - Ivoclar Vivadent] of four thicknesses (0.5 mm, 1.0 mm, 1.5 mm and 2.0 mm). As control, the cement was light-cured without interposition of ceramics. The degree of conversion was evaluated by FTIR spectroscopy (n=5). Data were analyzed with one-way ANOVA and Tukey's test (α=0.05). Significant differences were observed among groups (p<0.001). The degree of conversion was similar to the control for all light-cured groups with interposition of ceramics of 0.5 mm and 1.0 mm (p>0.05). Among 1.5-mm-thick veneers, IPS e.max LT was the only one that showed different results from the control (p<0.05). At the thickness of 2.0 mm, only the IPS e.max LT and HT veneers were able to produce cements with degrees of conversion similar to the control (p>0.05). The degree of conversion of the evaluated light-cured resin cement depends on the thickness and type of ceramics employed when veneers thicker than 1.5 mm are cemented.