This work aimed the development of an analytical procedure using inductively coupled plasma mass spectrometry (ICP-MS) in four modes of operation for simple and fast determination of Al, Ag, As, B, Ba, Be, Ca, Cd, Co, Cr, Cu, Fe, Li, Mg, Mn, Na, Ni, Pb, Sb, Se, Tl, Hg, V, U, and Zn in fresh and sea water samples attending simultaneously four Brazilian regulations, Ordinance No. 2914, ANVISA No. 274 and CONAMA Nos. 357 and 396. High matrix introduction system enables the introduction of sea water (3.5% m v-1 of NaCl) only 2-fold diluted. Collision cell mode was efficient to overcome polyatomic interferences. The procedure presented limits of detection (LODs) lower than maximum concentrations allowed by regulations. The CRM NIST 1643e and addition-recovery experiments were used to check accuracy and recoveries varied from 84 to 115%. ICP-MS combined with collision cell mode and aerosol dilution led to accurate and simultaneous determinations of 25 elements at different concentration levels in samples containing high contents of total dissolved solids.

This work describes a procedure for determination of Cd, Ni and V in spices by high-resolution continuum source graphite furnace atomic absorption spectrometry (HR-CS GF AAS) using direct solid sampling (SS). The use of Pd/Mg(NO3)2 as modifier for Cd, and an additional air-assisted pyrolysis step allowed the use of aqueous calibration for all analytes. Accuracy was checked by analysis of certified reference materials (CRMs) and the results were in agreement to certified values at 95% confidence level (t-test). Eight samples of spices were analyzed by the proposed procedure and by inductively coupled plasma mass spectrometry (ICP-MS). The found concentrations were 88-233 ng g-1 Cd , 113-2842 ng g-1 Ni and 154-1007 ng g-1 V, with precision generally better than 12%. Results obtained by the proposed procedure were in agreement with those obtained by microwave-assisted digestion and ICP-MS determination. The limits of detection were 0.2, 18 and 7 ng g-1 for Cd, Ni and V, respectively.

A espectrometria de absorção atômica em forno de grafite de alta resolução com fonte contínua (HR-CS GF AAS) é proposta para determinar Pb em sombra de olho e blush empregando a análise direta de sólidos. O emprego da mistura de modificadores químicos Pd(NO3)2 + Mg(NO3)2 possibilitou a calibração aquosa de 0,25 a 2,5 ng Pb (r = 0,998). O desempenho do método proposto foi avaliado por meio da análise de digeridos de sombra e de blush por espectrometria de absorção atômica em forno de grafite com fonte de linhas (LS GF AAS) como técnica comparativa. Os resultados obtidos por HR-CS GF AAS e LS GF AAS foram concordantes entre si a um nível de confiança de 95% (teste t pareado). O limite de quantificação (massa seca) foi de 0,020 ng mg–1. A concentração de Pb nas amostras de sombra de olho e de blush variou de 1,222 a 9,632 ng mg–1 e 0,362 a 28,091 ng mg–1, respectivamente.

Direct solid sampling is proposed for Pb determination in eye shadow and blush samples by high-resolution continuum source graphite furnace atomic absorption spectrometry (HR-CS GF AAS). A mixture of Pd(NO3)2 + Mg(NO3)2 was employed as chemical modifier, and aqueous calibration (0.25-2.5 ng Pb, r = 0.998) was obtained. Accuracy of the determination of Pb in eye shadow and blush samples by the proposed method was verified by line source graphite furnace AAS as a comparative technique employing digested samples. The results obtained by the two methods were in agreement at a 95% confidence level (paired t-test). The limit of quantification (dry mass) was 0.020 ng mg–1. The Pb content in the eye shadow and blush samples varied between 1.222 and 9.632 ng mg–1 and 0.362 and 28.091 ng mg–1, respectively.