ABSTRACT Objective: The aim was to characterize blood glucose fluctuations in patients with fulminant type 1 diabetes (FT1DM) at the stable stage using continuous blood glucose monitoring systems (CGMSs). Subjects and methods: Ten patients with FT1DM and 20 patients with classic type 1 diabetes mellitus (T1DM) (the control group) were monitored using CGMSs for 72 hours. Results: The CGMS data showed that the mean blood glucose (MBG), the standard deviation of the blood glucose (SDBG), the mean amplitude glycemic excursions (MAGE), the blood glucose areas and the percentages of blood glucose levels below 13.9 mmol/L were similar between the two groups. However, the percentage of blood glucose levels below 3.9 mmol/L was significantly higher in the FT1DM group compared to the T1DM group (p < 0.05). The minimum (Min) blood glucose level in the FT1DM group was significantly lower than that of the T1DM group (p < 0.05). Patients with FT1DM had severe dysfunction of the islet beta cells and alpha cells compared to patients with T1DM, as indicated by lower C-peptide values and higher glucagon/C-peptide values. Conclusion: In conclusion, patients with FT1DM at the stable stage were more prone to hypoglycemic episodes as recorded by CGMSs, and they had a greater association with severe dysfunction of both the beta and alpha islet cells compared to patients with T1DM.

OBJECTIVES:The transoral atlantoaxial reduction plate system treats irreducible atlantoaxial dislocation from transoral atlantoaxial reduction plate-I to transoral atlantoaxial reduction plate-III. However, this system has demonstrated problems associated with screw loosening, atlantoaxial fixation and concealed or manifest neurovascular injuries. This study sought to design a set of individualized templates to improve the accuracy of anterior C2 screw placement in the transoral atlantoaxial reduction plate-IV procedure.METHODS:A set of individualized templates was designed according to thin-slice computed tomography data obtained from 10 human cadavers. The templates contained cubic modules and drill guides to facilitate transoral atlantoaxial reduction plate positioning and anterior C2 screw placement. We performed 2 stages of cadaveric experiments with 2 cadavers in stage one and 8 in stage two. Finally, guided C2 screw placement was evaluated by reading postoperative computed tomography images and comparing the planned and inserted screw trajectories.RESULTS:There were two cortical breaching screws in stage one and three in stage two, but only the cortical breaching screws in stage one were ranked critical. In stage two, the planned entry points and the transverse angles of the anterior C2 screws could be simulated, whereas the declination angles could not be simulated due to intraoperative blockage of the drill bit and screwdriver by the upper teeth.CONCLUSIONS:It was feasible to use individualized templates to guide transoral C2 screw placement. Thus, these drill templates combined with transoral atlantoaxial reduction plate-IV, may improve the accuracy of transoral C2 screw placement and reduce related neurovascular complications.