OBJECTIVES: High incidence and case fatality of unstable angina (UA) is, to a large extent, a consequence of the lack of highly sensitive and specific non-invasive markers. Circulating microRNAs (miRNAs) have been widely recommended as potential biomarkers for numerous diseases. In the present study, we characterized distinctive miRNA expression profiles in patients with stable angina (SA), UA, and normal coronary arteries (NCA), and identified promising candidates for UA diagnosis. METHODS: Serum was collected from patients with SA, UA, and NCA who visited the Department of Cardiovascular Diseases of the Meizhou People’s Hospital. Small RNA sequencing was carried out on an Illumina HiSeq 2500 platform. miRNA expression in different groups of patients was profiled and then confirmed based on that in an independent set of patients. Functions of differentially expressed miRNAs were predicted using gene ontology classification and Kyoto Encyclopedia of Genes and Genomes pathway analysis. RESULTS: Our results indicated that circulating miRNA expression profiles differed between SA, UA, and NCA patients. A total of 36 and 161 miRNAs were dysregulated in SA and UA patients, respectively. miRNA expression was validated by reverse transcription quantitative polymerase chain reaction. CONCLUSION: The results suggest that circulating miRNAs are potential biomarkers of UA.

ABSTRACT: Yellowing is a key stage in the curing of flue-cured tobacco (Nicotiana tobacum L.) as much of the chemical transformation occurs during this period. This study examined the effect of different yellowing degrees on the value of flue-cured tobacco leaves at the farm level for both processing and manufacturing. The study was conducted in the counties of Chuxiong, Dali, and Yuxi in Yunnan, China over two years. Yellowing treatments have been designed to have either a mild or a regular yellowing degree. Yield, value, appearance, suction property, smoking characteristics, and physical resistance to further processing were investigated to evaluate the effect of degree of yellowing on the industrial utilization of flue-cured tobacco leaves. The regular yellowing degree enhanced yield, value, and appearance compared to the mild yellowing degree, regardless of cultivar or location; however, physical resistance to further processing and the suction property of the mild yellowing degree treatment were better than with the regular yellowing degree regardless of cultivar or location. Furthermore, although the regular yellowing degree recorded higher smoking characteristic scores than the mild yellowing degree immediately after flue-curing, the scores of mild yellowing degree leaves could be further augmented by increasing intensity in the re-drying stage. The smoking characteristic score in the regular yellowing degree can only be increased by low intensity re-drying, and significantly decreased by mild and high intensity re-drying. Therefore, in terms of industrial utilization, mild yellowing is the better choice for flue-curing tobacco. This study also suggested that the current regular yellowing stage in Yunnan should be shortened to meet the demands of the traditional tobacco industry.

Abstract The embrittlement and softening behaviors in heat affected zone of X90 pipeline steel were studied, and the influence of weld thermal cycle on microstructure and mechanical properties were discussed by combining the effect of peak temperature on the phase transition point (Ar3). Results show that there are embrittlement and softening zones existed in heat affected zone of X90 pipeline steel. The peak temperature greatly affected the austenitizing and its grain size, thereby affected phase transition during cooling process. The embrittlement in critical heat affected zone at 750 °C was caused by brittle bainite and M /A islands formed during cooling, because little austenite was formed during heating. While, the embrittlement in coarse grain heat affected zone was caused by austenite grain coarsen, which transformed to the coarse bainite after cooling. The softening zone attributed to the polygonal ferrite and granular ferrite after cooling, which came from fine and ununiformed austenite formed during reheating process. Ar3 decreased with the increase of Cu, Cr or Mo content in steel, and the BF content in CGHAZ and GB and AF content in FGHAZ increased.