O objetivo dessa pesquisa foi mensurar a espessura da camada hibrida de adesao (CH), o comprimento dos prolongamentos resinosos (Tags) e a resistencia de uniao (RU) em um mesmo especime e analisar a correlacao entre esses fatores, usando o adesivo autocondicionante Adper Prompt L Pop em dentina higida. Dez molares humanos foram utilizados e apos a realizacao dos procedimentos restauradores, de acordo com os fabricantes, cada especime foi cortado ao meio no sentido mesio/distal. Em uma hemi-seccao dental os especimes foram descalcificados para analise e mensuracao dos tags e da camada hibrida de adesao em microscopia optica comum (AXIOPHOT, 400X). Na outra hemi-seccao, foi realizado o teste de microtracao em uma velocidade de 0,5 mm/min ate sua ruptura. A superficie fraturada foi mensurada e classificada de acordo com o tipo de fratura observada em microscopia eletronica de varredura. Os valores obtidos para os fatores em analise, correspondentes a cada especime foram submetidos a um teste de correlacao. As medias correspondentes a CH, Tags e RU foram 3,36μm, 12,97 μm 14,10 MPa, respectivamente. Nao foi observado correlacao entre a CH e RU (R2= 0,011, p>0,05) e entre os Tags e RU (R2= 0,038). Diante dos resultados, observamos nao haver correlacao entre a camada hibrida e a resistencia a tracao, assim como entre os tags e a resistencia a tracao do sistema adesivo autocondicionante empregado.
The objective of this study was to measure the thickness of the hybrid layer (HLT), length of resin tags (RTL) and bond strength (BS) in the same teeth, using a self-etching adhesive system Adper Prompt L Pop to intact dentin and to analyze the correlation between HLT and RTL and their BS. Ten human molars were used for the restorative procedures and each restored tooth was sectioned in mesio-distal direction. One section was submitted to light microscopy analysis of HLT and RTL (400×). Another section was prepared and submitted to the microtensile bond test (0.5 mm/min). The fractured surfaces were analyzed using scanning electron microscopy to determine the failure pattern. Correlation between HLT and RTL with the BS data was analyzed by linear regression. The mean values of HLT, RTL and BS were 3.36 μm, 12.97 μm and 14.10 MPa, respectively. No significant relationship between BS and HLT (R2= 0.011, p>0.05) and between BS and RTL (R2= 0.038) was observed. The results suggested that there was no significant correlation between the HLT and RTL with the BS of the self-etching adhesive to dentin.