Abstract After performing localized repairs, it is customary to observe the reappearance of corrosion points in the region adjacent to the repaired area, a situation usually called the incipient anode phenomenon. Although there are several studies have on the subject, there are still controversial aspects regarding its causes, location, and progression over time. To investigate these gaps in knowledge, samples were molded with unrepaired chloride-contaminated substrate and repaired with repair mortar containing 0%, 10%, and 20% binder replacement with rice husk ash (RHA). Then, measurements of the electrochemical variables of density and corrosion potential were carried out, as well as the destructive inspection of part of the samples. After the measurements, an increase in corrosion rates was observed after the repair, in the repair-substrate interface. In the destructive inspection, significant deterioration also was observed in the repair-substrate interface region, as well as inside the substrate. Regarding the effect of replacing the binder with RHA, no relevant reduction in the incipient anode was identified in the mortars with 10% and 20% RHA. On the other hand, a possible reduction in the passivation capacity of mortar with 20% RHA content was noted. repairs area phenomenon subject causes location time knowledge chloridecontaminated chloride contaminated 0 0% 10 20 . (RHA) Then out repairsubstrate hand noted 1 2 (RHA
Resumo Após a realização de reparos localizados, costuma-se observar o ressurgimento de pontos de corrosão na região adjacente à área reparada, situação usualmente denominada ânodo incipiente. Embora tenham sido feitas diversas pesquisas a respeito do tema, ainda restam controversos aspectos em relação às suas causas, localização e progressão no tempo. Com objetivo de investigar essas lacunas no conhecimento, moldaram-se amostras com substrato contaminado por cloretos não reparadas e reparadas com argamassa de reparo contendo substituição de ligante por sílica de casca de arroz (SCA) nos teores de 0%, 10% e 20%. Em seguida, realizaram-se aferições das variáveis eletroquímicas de densidade e potencial de corrosão, bem como a inspeção destrutiva de parte das amostras. Após as aferições, observou-se aumento nas densidades de corrosão após o reparo, na interface substrato-reparo. Na inspeção destrutiva, também foi constatada deterioração significativa na interface reparo-substrato, bem como em algumas regiões no interior do substrato. Em relação ao efeito da substituição de ligante por SCA, não foi identificada redução relevante do ânodo incipiente nas argamassas com 10% e 20% de SCA. Por outro lado, notou-se possível redução da capacidade de passivação da argamassa com teor de 20% de SCA. localizados costumase costuma se reparada tema causas tempo conhecimento moldaramse moldaram SCA (SCA 0 0% 10 20 seguida realizaramse realizaram observouse observou substratoreparo. substratoreparo reparo. substrato-reparo reparosubstrato, reparosubstrato substrato, reparo-substrato lado notouse notou 1 2