Abstract To evaluate the release of bisphenol-A glycidyl methacrylate (BisGMA), triethylene glycol dimethacrylate (TEGDMA), bisphenol A (BPA), and phthalates of the composite resin used in the bonding of spurs applied in the treatment of children with anterior open bite and its effects on human keratinocytes. Methodology Saliva samples of 22 children were collected before spur attachment (baseline) and 30 minutes (min) and 24 hours (h) after spur bonding. Analysis was performed using high-performance liquid chromatography (HPLC) coupled to tandem mass spectrometry (HPLC–MS/MS) and gas chromatography coupled to mass spectrometry (GC–MS). Standardized resin increments were added to three different dilutions of the cell culture medium. Keratinocytes (HaCaT) were cultivated in the conditioned media and evaluated for cell viability (MTT) and cell scratch assay. Results The levels of BisGMA (1.74±0.27 μg/mL), TEGDMA (2.29±0.36 μg/mL), and BPA (3.264±0.88 μg/L) in the saliva after 30 min, in comparison to baseline (0±0 μg/mL, 0±0 μg/mL, and 1.15±0.21 μg/L, respectively), presented higher numbers. After 24 h, the levels of the monomers were similar to the baseline. Phthalates showed no significant difference among groups. HaCat cells showed increased viability and reduced cell migration over time after exposure to methacrylate-based resin composites. Conclusion Resin composites, used to attach spurs in children with anterior open bite during orthodontic treatment, release monomers after polymerization and can influence the behavior of human keratinocytes, even at very low concentrations. Orthodontists should be aware of the risks of the resinous compounds release and preventive procedures should be held to reduce patient exposure. bisphenolA BisGMA, , (BisGMA) TEGDMA, (TEGDMA) BPA, (BPA) keratinocytes 2 (baseline 3 min (min h (h highperformance high performance HPLC (HPLC HPLC–MS/MS HPLCMSMS MS (HPLC–MS/MS GC–MS. GCMS GC–MS . GC (GC–MS) medium HaCaT (HaCaT MTT (MTT assay 1.74±0.27 174027 1 74 0 27 (1.74±0.2 μgmL μg/mL μg mL μg/mL) 2.29±0.36 229036 29 36 (2.29±0.3 3.264±0.88 3264088 264 88 (3.264±0.8 μg/L μgL L 00 (0± 0± 115021 15 21 1.15±0.2 respectively, respectively respectively) numbers groups methacrylatebased based composites concentrations (BisGMA (TEGDMA (BPA (GC–MS 1.74±0.2 17402 7 (1.74±0. 2.29±0.3 22903 (2.29±0. 3.264±0.8 326408 26 8 (3.264±0. (0 11502 1.15±0. 1.74±0. 1740 (1.74±0 2.29±0. 2290 (2.29±0 3.264±0. 32640 (3.264±0 ( 1150 1.15±0 1.74±0 174 (1.74± 2.29±0 229 (2.29± 3.264±0 3264 (3.264± 115 1.15± 1.74± 17 (1.74 2.29± (2.29 3.264± 326 (3.264 11 1.15 1.74 (1.7 2.29 (2.2 3.264 32 (3.26 1.1 1.7 (1. 2.2 (2. 3.26 (3.2 1. (1 2. (2 3.2 (3. 3. (3

The present study aimed at the evaluation of Passiflora coccinea (Aubl.) antioxidant and photo protective in vitro activities, looking forward to their application as antiaging or sunscreen agents in cosmetic formulations. Methanolic and glycolic leaf extracts were prepared by three methods: ultrasound assisted extraction (UAE, 30 min.), maceration at room temperature (72 h) and maceration at 30 ºC (72 h). The antioxidant activities of the extracts were measured by DPPH and ORAC-FL assays and they were incorporated into a cosmetic emulsion to have their sun protection factor (SPF) measured spectrophotometricaly. The antioxidant activity of the emulsions were measured by DPPH and ORAC as well. C-glycosyl-flavones were identified in the extracts by ESI-MS/MS, in comparision with standards. The UAE methanolic extract and the maceration at 30 ºC glycolic extract were submmited to HPLC-DAD analysis and isovitexin was quantifyed in both by a validated method. The methanolic extract antioxidant activity was independent of the extraction method, higher than reported for other species of Passiflora and detectable when incorporated into the emulsion formulation. Maceration at 30oC was the most suitable method for glycolic extraction and its antioxidant activity was lower than the value presented by the methanolic extracts. None of the extracts exhibited a SPF value. Isovitexin in the UAE methanolic extract was 12.67 times higher than the most active glycolic extract, aside of their similar chromatographic profiles. Although a SPF value was not detected, the results indicate that P. coccinea can be a potential new source of antioxidants for topical antiaging formulations.

Hydrophilic interaction liquid chromatography (HILIC) has been gaining increased attention for its effective separation of highly polar compounds, which include carbohydrates, amino acids, pharmaceutical compounds, proteins, glycoproteins, nucleosides, etc. Polar compounds are usually poorly retained on reverse-phase liquid chromatography (RP-HPLC) columns or have poor solubility in the apolar mobile phase of normal-phase high performance liquid chromatography (NP-HPLC). Since HILIC uses organic solvents such as ACN or MeOH ( > 70%), also used in RP-HPLC and polar stationary phases similar to NP-HPLC (bare silica, diol, amino, amide, saccharide, zwitterionic stationary phases, etc.), it represents a hybrid of the two separation modes. The high organic content in the MP leads to good compatibility with mass spectrometry (MS), increasing the detectivity. This review describes the fundamentals of HILIC and highlights some interesting applications.

OBJECTIVE: To detect the presence and concentration of methylparaben in cartridges of commercial Brazilian local anesthetics. MATERIAL AND METHODS: Twelve commercial brands (4 in glass and 8 in plastic cartridges) of local anesthetic solutions for use in dentistry were purchased from the Brazilian market and analyzed. Different lots of the commercial brands were obtained in different Brazilian cities (Piracicaba, Campinas and São Paulo). Separation was performed using high performance liquid chromatography (HPLC) with UV-Vis detector. The mobile phase used was acetonitrile:water (75:25 - v/v), pH 4.5, adjusted with acetic acid at a flow rate of 1.0 ml.min-1. RESULTS: When detected in the solutions, the methylparaben concentration ranged from 0.01% (m/v) to 0.16% (m/v). One glass and all plastic cartridges presented methylparaben. CONCLUSION: 1. Methylparaben concentration varied among solutions from different manufacturers, and it was not indicated in the drug package inserts; 2. Since the presence of methylparaben in dental anesthetics is not regulated by the Brazilian National Health Surveillance Agency (ANVISA) and this substance could cause allergic reactions, it is important to alert dentists about its possible presence.

Os parabenos, empregados como conservantes em alimentos, foram analisados por eletrocromatografia capilar, empregando uma coluna comercial recheada com partículas de sílica-C18 (3 µm, 40 cm × 100 µm d. i.) como fase estacionária de separação. Para otimizar a separação destes conservantes foram avaliados os efeitos da composição da fase móvel na separação, bem como a voltagem e as condições de injeção. O comportamento de retenção dos analitos foi fortemente influenciado pela proporção de acetonitrila na fase móvel. A separação dos parabenos foi alcançada em 18,5 min com uma fase móvel contendo tampão tris(hidroximetil)aminometano e acetonitrila na proporção 50:50 v/v. O método foi aplicado na análise quantitativa de parabenos em adoçantes empregando a injeção direta das amostras.

Parabens, common food preservatives, were analysed by capillary electrochromatography, using a commercial C18 silica (3 µm, 40 cm × 100 µm i. d.) capillary column as separation phase. In order to optimise the separation of these preservatives, the effects of mobile phase composition on the separation were evaluated, as well as the applied voltage and injection conditions. The retention behavior of these analytes was strongly influenced by the level of acetonitrile in the mobile phase. An optimal separation of the parabens was obtained within 18.5 minutes with a pH 8.0 mobile phase composed of 50:50 v/v tris(hydroxymethyl)aminomethane buffer and acetonitrile. The method was successfully applied to the quantitative analysis of paraben preservatives in sweetener samples with direct injection.

This review describes the advantages and disadvantages of using capillary liquid chromatography (CLC), which is considered the newest member in the analytical separation science arsenal. Although CLC has tremendous potential for being the next major innovation in separatory analysis, it has not yet obtained great popularity compared to conventional high performance (and ultra-high performance) liquid chromatography. Comparisons are made between these techniques and some of the reasons that CLC has not yet reached its potential will be advanced.

Plastic packaging materials intended for use in food packaging is an area of great interest from the scientific and economic point of view due to the irreversible internationalization and globalization process of food products. Nevertheless, a debate related to food safety aspects has emerged within the scientific community. Therefore, the development of analytical methods that allow identifying and quantifying chemical substances of toxicological potential in the packaging is considered essential. This article focuses on the main analytical methods, including validation parameters, as well as extraction and quantification techniques for determination of volatile organic compounds from food packaging materials.

The validation of an analytical method is fundamental to implementing a quality control system in any analytical laboratory. As the separation techniques, GC, HPLC and CE, are often the principal tools used in such determinations, procedure validation is a necessity. The objective of this review is to describe the main aspects of validation in chromatographic and electrophoretic analysis, showing, in a general way, the similarities and differences between the guidelines established by the different Brazilian and international regulatory agencies.