RESUMO Objetivo: O objetivo deste estudo foi avaliar o nível de conhecimento dos acadêmicos de odontologia da UFES sobre o tratamento clareador caseiro. Métodos: Como metodologia, foi realizado um estudo descritivo e transversal por meio da aplicação de questionário a 109 estudantes contendo perguntas sobre o clareamento dental caseiro, cuidados técnicos e possíveis riscos do tratamento. Os dados foram tabulados e submetudos à estatística descritiva. Resultados: Do total de estudantes, 88,99% disse conhecer os fatores que limitam ou contraindicam o tratamento clareador; 16,51% dos estudantes reconhecem o peróxido de hidrogênio como possível indutor de câncer bucal; 30,27% dos estudantes realizaram o clareamento dental dentro da Universidade, 44,03% realizaram o clareamento dental fora da Universidade sem supervisão profissional. Além disso, 56,88% acreditam que são necessários anamnese e exame clínico antes de realizar o tratamento clareador. Conclusão: Conclui-se que os alunos têm conhecimento limitado sobre determinados pontos do clareamento dental caseiro. Os estudantes conhecem os fatores de risco do tratamento clareador, exceto a respeito do peróxido de hidrogênio ser um possível indutor de câncer bucal. Pode-se inferir que os acadêmicos relevam a importância da associação do exame clínico com a anamnese do paciente antes de se realizar o tratamento clareador. A maioria dos estudantes tem realizado o clareamento dental fora da Universidade, o que chama atenção para reforçar o conhecimento sobre as questões éticas da profissão. Objetivo caseiro Métodos metodologia 10 descritiva Resultados 8899 88 99 88,99 1651 16 51 16,51 bucal 3027 30 27 30,27 4403 44 03 44,03 profissional disso 5688 56 56,88 Conclusão Concluise Conclui Podese Pode profissão 1 889 8 9 88,9 165 5 16,5 302 3 2 30,2 440 4 0 44,0 568 56,8 88, 16, 30, 44, 56,

ABSTRACT Objective: The aim of this study was to evaluate the level of knowledge of UFES dental students about home bleaching treatment. Methods: As a methodology, a descriptive and cross-sectional study was carried out through the application of practice to 109 students, containing questions about home tooth whitening, technical care and possible complications of the treatment. Data were tabulated and submitted to descriptive statistics. Results: Of the total number of students, 88.99% said they knew the factors that limit or contraindicate the bleaching treatment, 16.51% of students recognize hydrogen peroxide as a possible inducer of oral cancer, 30.27% of the students had their teeth whitened inside the University, 44.03% had their teeth whitened outside the University without professional supervision. In addition, 56.88% believe anamnesis and clinical examination are necessary before the bleaching treatment. Conclusion: It is concluded that students have limited knowledge about certain points of at-home tooth whitening. Students know the risk factors of bleaching treatment, except regarding hydrogen peroxide being a possible inducer of oral cancer. It can be inferred that academics highlight the importance of associating the clinical examination with the patient’s anamnesis before performing the bleaching treatment. Most students have had their teeth whitened outside the University, which calls attention to reinforce knowledge about the ethical issues of the profession. Objective treatment Methods methodology crosssectional cross sectional 10 whitening statistics Results 8899 88 99 88.99 1651 16 51 16.51 cancer 3027 30 27 30.27 4403 44 03 44.03 supervision addition 5688 56 56.88 Conclusion athome at patients patient s profession 1 889 8 9 88.9 165 5 16.5 302 3 2 30.2 440 4 0 44.0 568 56.8 88. 16. 30. 44. 56.

Abstract Several anti-proteolytic dentin therapies are being exhaustively studied in an attempt to reduce dentin bond degradation and improve clinical performance and longevity of adhesive restorations. Objectives This study assessed the effect of epigallocatechin-3-gallate (EGCG) on long-term bond strength when incorporated into adhesives. Material and Methods Adhesive systems were formulated with EGCG concentrations of 0 wt%: (no EGCG; control); 0.5 wt% EGCG; 1.0 wt% EGCG, and 1.5 wt% EGCG. Flexural strength (FS), modulus of elasticity (ME), modulus of resilience (MR), compressive strength (CS), degree of conversion (DC), polymerization shrinkage (PS), percentage of water sorption (%WS), percentage of water solubility (%WL) and cytotoxicity properties were tested. Dentin microtensile bond strength (µTBS) was evaluated after 24 h and again after 6 months of water storage. The adhesive interface was analyzed using scanning electron microscopy (SEM). Results No significant differences were found among the groups in terms of FS, ME, MR, CS and PS. EGCG-doped adhesives increased the DC relative to the control group. EGCG concentrations of 1.0 wt% and 0.5 wt% decreased the WS of adhesives. WL decreased in all cases in which EGCG was added to adhesives, regardless of the concentration. EGCG concentrations of 1.0 wt% and 0.5 wt% reduced cytotoxicity. EGCG concentrations of 1.0 wt% and 0.5 wt% preserved µTBS after 6 months of storage, while 1.5 wt% EGCG significantly decreased µTBS. SEM: the integrity of the hybrid layer was maintained in the 0.5 wt% and 1.0 wt% EGCG groups. Conclusion EGCG concentrations of 1.0 wt% and 0.5 wt% showed better biological and mechanical performance, preserved bond strength and adhesive interface, and reduced cytotoxicity.

Resumo Introdução Este trabalho serve como um alerta para dentistas e pesquisadores, que alguns cimentos resinosos duais podem não polimerizar completamente sob alguns tipos de coroas protéticas. Objetivo Analisar o grau de polimerização de cimentos resinos duais, sob barreiras protéticas, por teste de microdureza. Material e método Três cimentos: Bistite II, RelyX ARC e Variolink II, foram fotopolimerizados através da interposição de vários tipos de barreiras, interpostas entre o cimento e a fonte de luz, formando os grupos: G1: sem barreira; G2: Resina composta Cesead; G3: Inceram alumina/Allceram; G4: IPS Empress; G5: Inceram zircônia/Allceram; G6: fragmento dental. Utilizou-se a luz halógena (650 mW/cm2) para fotoativação e a microdureza foi avaliada: 50gf durante 15s (MicrohardnessTester FM 700), em dois períodos (30min e 24h) pós ativação. Os dados foram submetidos à ANOVA e teste de Tukey (5%). As interposições de Inceram alumina e Inceram zircônia resultaram na polimerização deficiente dos cimentos, impossibilitando a realização dos ensaios. Resultado Para o fator cimento, o Bistite revelou a maior microdureza, seguido do RelyX e do Variolink (p<0,05). A barreira influenciou a microdureza, sendo que os maiores valores foram obtidos sem barreira, seguida do dente. Empress e Cesead proporcionaram os menores valores de microdureza e não diferiram entre si. Conclusão A barreira afetou negativamente a microdureza dos cimentos resinosos duais; o período de avaliação não afetou os valores de microdureza para quase todas as condições testadas; existe um fator limitante do ativador químico na polimerização de alguns cimentos resinosos duais, e seu desempenho é dependente do produto.

Abstract Introduction This study serves as a warning to dentists and researchers that dual-cured resin cements may not polymerize completely under some prosthetic crowns. Objective The aim of this study was to analyse the polymerization degree of dual-cured resin cements under prosthetic barrier, by microhardness test. Material and method Three cements (Bistite II, RelyX ARC and Variolink II) were light-cured through different barriers, placed between the cement and the light source: G1: without barrier; G2: composite resin (Cesead); G3: Inceram alumina; G4: IPS Empress; G5: Inceram zirconia; G6: tooth fragment. Photopolymerization was carried out using a halogen light unit (650 mW/cm2); microhardness was evaluated using the Microhardness Tester FM 700, under a load of 50gf with a dwell time of 15s, at two evaluation times (30min and 24h). Result The results were submitted to ANOVA and Tukey tests (5%). Both Inceram alumina and Inceram zirconia ceramic barriers hindered polymerization. Bistite, followed by RelyX and Variolink, exhibited the highest microhardness values (p<0.05). As the highest values were obtained without a barrier, it was determined that the barrier, followed by the tooth, influenced microhardness. Both Empress and Cesead had the smallest microhardness values but with no statistically significant difference between them. Conclusion The barrier negatively affected the microhardness of dual-cured resin cements; evaluation time did not affect microhardness values for most of the conditions tested. There is a limited effect of the chemical activator on the polymerization of some dual-cured cements, and their performance is product specific.

OBJETIVO: Esta pesquisa verificou os efeitos da tecnologia Grander na alteração da tensão superficial e ângulo de contato de um sistema adesivo autocondicionante. METODOLOGIA: O sistema adesivo autocondicionante Xeno III (Dentsply) e a água destilada foram modificados pelo contato físico com a unidade flexible do sistema Grander para revitalização de águas por 48 horas, resultando em 4 grupos: Grupo 1 - sistema adesivo Xeno III em condições de normalidade; Grupo 2 - sistema adesivo Xeno III modificado pelo sistema Grander; Grupo 3 - água destilada em condições de normalidade; Grupo 4 - água destilada modificada pelo sistema Grander. A tensão superficial dos líquidos foi verificada em goniômetro utilizando cinco medidas para cada gota de líquido. O ângulo de contato foi medido com o goniômetro sobre os substratos placa de titânio e dentes bovinos. Os dados foram submetidos aos testes ANOVA e Tukey (5%). RESULTADOS: Houve redução significativa da tensão superficial da água com a modificação pelo sistema Grander. Não houve redução da tensão superficial e ângulo de contato para o sistema adesivo Xeno III. CONCLUSÃO: A tecnologia Grander não interferiu com a tensão superficial e o ângulo de contato para o sistema adesivo Xeno III.

PURPOSE: The objective of this study was to evaluate the influence of the Grander technology in reducing the surface tension and contact angle of a self-etch adhesive system. METHODS: Distilled water and Xeno III self-etch adhesive system (Dentsply) were modified by physical contact with the Flexible unit Grander system to revitalize water, for 48 hours, resulting in four groups: Group 1 - Xeno III under normal conditions; Group 2 - Xeno III modified by Grander; Group 3 - distilled water under normal conditions; Group 4 - distilled water system modified by the Grander system;. Surface tension and contact angle (dentin substrate and titanium plate) of the adhesive system and water in normal and Grander-modified conditions was measured with a goniometer. Data were analyzed by ANOVA and Tukey test (5%). RESULTS: Grander technology reduced the surface tension of water but not of the adhesive system Xeno III. The contact angle property of the adhesive ystem was not affected. CONCLUSION: Grander technology did not interfere with the surface tension and contact angle physical properties of the Xeno III self-etch adhesive system.

This study evaluated the effect of antioxidant agents on microtensile bond strengths (mTBS) of composite to bleached enamel. Fifteen freshly extracted human third molars were selected and randomly assigned to 6 groups (n = 5): (NB) enamel not bleached, (B) bleached enamel, (BR7) bleached enamel and restored 7 days later, (BSA) bleached enamel+sodium ascorbate, (BMC) bleached enamel+malvidin chloride, (BPC) bleached enamel+pelargonidin chloride. The groups were bleached with 38% hydrogen peroxide (HP - Opalescence Xtra Boost) and restored with Single Bond+Filtek Z350. The specimens were thermocycled and submitted to a microtensile load at 1 mm/min crosshead speed. The data were evaluated by ANOVA and Tukey test at 5% of significance. The mean and standard-deviation for all groups were: NB: 30.95(±11.97)a; BSA: 30.34(±8.73)a, BPC: 22.81(6.00)b, BR7: 21.41(±6.12)b, B: 14.10(±4.45)c, BMC: 13.25(±6.02)c. Sodium ascorbate reversed the bond strengths to enamel immediately after bleaching.