Abstract This work investigated the effect of thermal treatment in an autoclave on the chemical, physical, and morphological properties of lignocellulosic fibers from açaí (Euterpe oleracea Mart), and the behavior of this treated fiber in polypropylene (PP) matrix composites with polypropylene-graft-maleic anhydride (PPgMA) as the coupling agent. The treated and untreated fibers were characterized by chemical composition, x-ray diffraction, FTIR spectroscopy, and thermogravimetry, scanning electron microscopy and tensile tests were carried out for the composites. The results showed that the thermal treatment modified the hemicellulose and lignin content and increased the fiber surface roughness, without compromising the thermal stability. The composite prepared with thermally treated fibers and PPgMA exhibited an increase in tensile strength but a reduction in tensile modulus. In conclusion, the thermal treatment of vegetable fiber is a promising technique for improving the performance of composites.

Abstract A sulfated polysaccharide fraction from the red alga Gracilaria intermedia (PLS) was obtained by papain digestion (60 °C, 30 min). The extract was subjected to colorimetry and turbidimetry analysis, Fourier transform infrared (FTIR) spectroscopy, 1H, 13 C and 2D 1H COSY nuclear magnetic resonance (NMR) and gas chromatography/mass spectrometry analysis. Antioxidant activity tests were performed (chelation of ferrous ion, total antioxidant capacity, and scavenging of DPPH radicals); significant activity of the extract indicated that these polysaccharides may be used as non-synthetic antioxidants. The rheological behavior of aqueous polysaccharide solutions was studied at 25 ± 1 °C using steady-shear and dynamic oscillatory measurements. All the solutions analyzed showed pseudoplastic behavior and potential to act as a thickening agent, as proved through a preliminary comparison with a commercial product used for this application.

<title>Abstract</title><p>In the literature there are several studies comparing the accuracy of various models in describing the PvT behavior of polymers. However, most of these studies do not provide information about the quality of the estimated parameters or the sensitivity of the prediction of thermodynamic properties to the parameters of the equations. Furthermore, there are few studies exploring the prediction of thermal expansion and compression coefficients. Based on these observations, the objective of this study is to deepen the analysis of Tait, HH (Hartmann-Haque), MCM (modified cell model) and SHT (simplified hole theory) equations of state in predicting the PvT behavior of polymers, for both molten and solid states. The results showed that all equations of state provide an adequate description of the PvT behavior in the molten state, with low standard deviations in the estimation of parameters, adequate sensitivity of their parameters and plausible prediction of specific volume, thermal expansion and isothermal compression coefficients. In the solid state the Tait equation exhibited similar performance to the molten state, while HH showed satisfactory results for amorphous polymers and difficulty in adjusting the PvT curve for semicrystalline polymers.</p>

No desenvolvimento de produtos, é de suma importância o conhecimento da influência das modificações da formulação nas propriedades sensoriais, físicas e químicas destes. O objetivo deste trabalho foi caracterizar sobremesas à base de soja com e sem adição de mucilagem de chia, utilizada como espessante alimentar. As formulações foram caracterizadas quanto as suas propriedades reológicas, °Brix, pH e cor. O perfil sensorial foi determinado por Análise Descritiva Quantitativa (ADQ), utilizando-se uma equipe de 10 julgadores treinados. Os resultados mostraram que as amostras não diferiram quanto aos valores de pH, °Brix e coordenada cromática a*. Quanto aos outros parâmetros de cor e reológicos, foram detectadas diferenças significativas entre as amostras, o que mostra a influência do tipo de espessante nestas características. Os resultados da ADQ mostraram que as amostras não apresentaram diferenças estatísticas quanto aos atributos, cor rosa, sabor de goiaba, sabor de soja e cremosidade, porém diferiram quanto à consistência. Com isso, conclui-se que a adição da mucilagem de chia pode ser feita sem causar grandes modificações ao produto.

In product development is important to study the influence of ingredients in the physical, chemical and sensory properties of the product. The aim of this study was to characterize soy-based desserts with and without addition of chia mucilage, used as food thickener. The formulations were characterized for their rheological properties, °Brix, pH and color. The sensory profile was determined by Quantitative Descriptive Analysis (QDA) using 10 trained judges. The results regarding to pH, ° Brix and color coordinate a* did not differ. Unlike these parameters, the other chromaticity coordinates and the rheological properties presented significant statistical differences between the samples. The QDA results showed that the samples did not differ as to the attributes, color, pink guava flavor, creaminess and flavor of soy, but differed in consistency. Thus, it is concluded that the addition of mucilage chia can be made without causing major changes to the product.

The influence of the composition and preparation method on the sol-gel transition temperature (Tsol-gel) and rheological response of poloxamer-based formulations was determined. Manual and more complex mechanical stirring were found to provide similar results. In addition, a linear dependence of Tsol-gel on the poloxamer content was observed in the range of concentrations analyzed, and a Poloxamer 407® concentration of 18% was selected. The addition of hyaluronic acid did not lead to significant changes in the Tsol-gel values. In contrast, the addition of microparticles caused a reduction in Tsol-gel without a significant reduction in gel strength, and pseudoplastic characteristics were observed, indicating that a thermoreversible gel was obtained with a rheology suitable for application in the treatment of burn wounds.