Advances in the use of 3D printing technology have led to the development of new low-cost devices. This technology features high versatility, considering the easy modulation of the materials depending on its objectives and applications. In this sense, we have developed a laboratory-built contact angle measuring device (lab-made). The device was composed by the assembly of 26 3D-printed pieces of different sizes and design printed using acrylonitrile-butadiene-styrene polymer. The device was designed in three main parts. The first part was related to the analysis, with the use of platforms for the sample surfaces positioning. The second part was made to support a micropipette, prepared to add the drop for analysis; and the third for the support of a smartphone, utilized to obtain the images. The device was applied for the measurement of contact angle on different surfaces, demonstrating its versatility and precision of the results. The obtained values are in accordance with others found in the literature. The developed device presented a low-cost (US$ 25.34 per device), easy assembly and operation.

INTRODUCTION: Electromagnetic interference caused by electric power lines adversely affects the signals of electronic instruments, especially those with low amplitude levels. This type of interference is known as common-mode interference. There are many methods and architectures used to minimize the influence of this kind of interference on electronic instruments, the most common of which is the use of band-reject filters. This paper presents the analysis, development, prototype and test of a new reconfigurable filter architecture for biomedical instruments, aiming to reduce the common-mode interference and preserve the useful signal components in the same frequency range as that of the noise, using the technique of dynamic impedance balancing. METHODS: The circuit blocks were mathematically modeled and the overall closed-loop transfer function was derived. Then the project was described and simulated in the VHDL_AMS language and also in an electronics simulation software, using discrete component blocks, with and without feedback. After theoretical analysis and simulation results, a prototype circuit was built and tested using as input a signal obtained from ECG electrodes. RESULTS: The results from the experimental circuit matched those from simulation: a 97.6% noise reduction was obtained in simulations using a sinusoidal signal, and an 86.66% reduction was achieved using ECG electrodes in experimental tests. In both cases, the useful signal was preserved. CONCLUSION: The method and its architecture can be applied to attenuate interferences which occur in the same frequency band as that of the useful signal components, while preserving these signals.