Resumo Objetivos A falha do componente glenoidal é a principal causa de revisão da artroplastia total do ombro (ATO) e sua frequência parece ser influenciada pelo design do componente. O objetivo deste estudo foi a avaliação clínica e radiográfica (através de raios X e tomografia computadorizada) dos resultados da ATO com componente glenoidal minimamente cimentado. Métodos O presente trabalho analisou ATOs realizadas com componente glenoidal Anchor Peg (DuPuy Synthes, Warsaw, IN, EUA) minimamente cimentado entre 2008 e 2013. Por um período mínimo de acompanhamento de 24 meses, escores segundo critérios da University of California at Los Angeles (UCLA) e imagens padronizadas de radiografia simples e tomografia computadorizada foram analisadas. A presença de osso entre as aletas do pino do componente central, que é um indicador de sua integração, foi avaliada nas imagens, bem como a presença de linhas radiotransparentes ao redor do componente glenoidal. Resultados Dezenove ombros de 17 pacientes foram avaliados. De acordo com o escore da UCLA, os resultados clínicos foram satisfatórios em 74% dos casos e moderados em 21% dos casos. O resultado foi ruim em um paciente. A integração de componentes foi observada em 58% dos pacientes, sendo total em 42% e parcial em 16% dos casos. Linhas radiotransparentes foram observadas em 52% dos pacientes. Nenhuma relação entre a integração de componentes e os resultados clínicos foi detectada. Conclusão A maioria dos pacientes submetidos à ATO com componente glenoidal minimamente cimentado apresentou resultados clínicos satisfatórios. Linhas radiotransparentes ao redor do componente glenoidal são comuns, mas não interferem nos resultados clínicos Nível de evidência IV; Série de caso; Estudo terapêutico.

Abstract Objectives Glenoid component failure is the main cause of total shoulder arthroplasty (TSA) revision, and component design seems to influence the failure rate. The aim of the present study was to clinically and radiographically (through X-rays and computed tomography scan) evaluate the results of TSA using a minimally cemented glenoid component. Methods Total should arthroplasties performed using the minimally cemented Anchor Peg (DuPuy Synthes, Warsaw, IN, USA) glenoid component between 2008 and 2013 were evaluated. University of California at Los Angeles (UCLA) scores were calculated, and standardized plain film and computed tomography images were obtained, at a minimum follow-up of 24 months. The presence of bone between the fins of the central component peg, which indicates its integration, was assessed on the images, as well the presence of radiolucent lines around the glenoid component. Results Nineteen shoulders in 17 patients were available for evaluation. According to the UCLA score, clinical results were satisfactory in 74% of cases and fair in 21% of cases. One patient had a poor result. Component integration was found in 58% of patients (total in 42% and partial in 16%). Radiolucent lines were observed in 52% of cases. No relationship was detected between component integration and clinical results. Conclusion Satisfactory clinical results were achieved in most patients undergoing TSA using a minimally cemented glenoid component. Radiolucent lines around the glenoid component are common, but do not interfere with the clinical results. Level of evidence IV; Case series; Treatment study.

Abstract In the last decade, various works have demonstrated that a class of artificial material called metamaterials (MTM) can synthesize mu-negative (MNG) media capable of evanescent-wave focusing which largely enhances the magnetic coupling between coils, which is the basic mechanism of Inductive Power Transmission (IPT) systems. In the present work, MTM-enhanced coupling in IPT systems is examined through analytical and numerical results, which are validated by experimental data. Adopting a transmission-line (TL) based approach to describe the general MTM-enhanced IPT system, it is evidenced that MNG MTMs can be interpreted as a negative impedance from a circuital point of view.

Abstract This paper deals with the effect of the Single-Input Multiple-Output spatial diversity on the OFDM mobile radio signal propagating in an urban channel. From measurements performed in Rio de Janeiro city, Brazil, by using two receiving antennas at diversity, the calculated capacity presented an improvement when compared to the individual one.

Abstract In this work three wideband mobile radio channel sounding methods are simulated and compared using computational tools. The considered sounders include the traditional STDCC and two other proposed sounding methods that are based on OFDM digital transmission and detection procedures and on matched filtering. The impact of the phase noise introduced by the receiver local oscillator in the precision of the examined sounders is analyzed by comparing the estimated channel results with the simulated reference channel. Other impairments factors like thermal noise or nonlinear distortion affecting the system are not considered.

Based on signal measurements carried out in the 5.8 GHz band, which is reserved for unlicensed WiMAX in Brazil, this paper evaluates narrowband and wideband characteristics on the suburban area of Tanguá city in Rio de Janeiro State. Fading statistics, coverage and adjusted prediction model such as Hata-COST 231, SUI and UFPA were used in order to find the model that best fits the measurement data before ultimately determining that the UFPA model proved to be the best one. Temporal dispersion is studied through the delay spread and coherence band calculated from the power delay profiles obtained in the sounded channel.

OBJETIVO: apresentar uma análise retrospectiva dos resultados clínico-funcionais e das complicações dos pacientes com artropatia do manguito rotador (AMR) submetidos à artroplastia reversa do ombro.MÉTODOS: foram selecionados pacientes com diagnóstico de AMR associada à pseudoparalisia da elevação anterior submetidos à artroplastia reversa do ombro com seguimento mínimo de um ano.RESULTADOS: foram coletadas informações pré-operatórias, por meio do nosso Registro de Artroplastias do Ombro e Cotovelo, que consistiam em idade, sexo, lateralidade, história de procedimentos prévios, escores funcionais de Constant, além da amplitude de movimentos pré-operatórios, conforme protocolo da American Academy of Shoulder and Elbow Surgery (Ases). Com seguimento médio de 44 meses, 17 pacientes (94%) estavam satisfeitos com o resultado do procedimento.CONCLUSÃO: a artroplastia reversa no tratamento da AMR em pacientes com pseudoparalisia do ombro demonstrou-se efetiva na melhoria, com significância estatística, da amplitude de movimentos de flexão anterior e abdução. Porém, nesta série não houve melhoria da amplitude dos movimentos de rotação externa e interna. A artroplastia reversa é um procedimento que restabelece a função da articulação do ombro em pacientes que previamente não apresentavam possibilidades terapêuticas.

OBJECTIVE: to present a retrospective analysis on the clinical-functional results and complications among patients with rotator cuff arthropathy (RCA) who underwent reverse arthroplasty of the shoulder.METHODS: patients with a diagnosis of RCA associated with pseudoparalysis of anterior elevation who underwent reverse arthroplasty of the shoulder with a minimum follow-up of one year were selected.RESULTS: preoperative information was gathered from our shoulder and elbow arthroplasty register, comprising age, sex, laterality, history of previous procedures, Constant's functional scores and the preoperative range of motion as described in the protocol of the American Academy of Shoulder and Elbow Surgery (ASES). After a mean follow-up of 44 months, 17 patients (94%) were satisfied with the result from the procedure.CONCLUSION: reverse arthroplasty for treating RCA in patients with pseudoparalysis of the shoulder was shown to be effective in achieving a statistically significant improvement in range of motion regarding anterior flexion and abduction. However, in this series, there was no improvement in range of motion regarding external and internal rotation. Reverse arthroplasty is a procedure that reestablishes shoulder joint function in patients who previously did not present any therapeutic possibilities.