Heat treatments and geometries have a significant influence on the mechanical behavior of endodontic files. Finite element analyses were performed to verify the effects due to each of these parameters in NiTi files. Two designs and three NiTi atomic structures (resultant from different heat treatments) were selected for this study. The geometries of the ProTaper Next X1 and ProTaper Universal S2 files, and the structures of fully austenitic (conventional superelastic), austenite treated, and fully R-phased were used. The mechanical responses were evaluated under flexion and torsion loading conditions described by ISO 3630-1 specification. According to the results, the design of the X1 file exhibit higher flexibility in comparison to the S2 model. Under torsional loads, S2 showed higher stiffness. The structures of fully austenitic showed the least flexibility under flexion and the highest torsional stiffness. The stress levels reached for the austenitic condition were uppermost. The treated condition that resulted in a fully R-phase file usually presented a higher level of flexibility with lower stress levels, indicating a longer life in fatigue when compared to the other treatments.

The ToF-SIMS technique was applied to analyze thin ZrO2 coatings deposited on the surface of a Ni-Ti alloy. Due to its nanostructured nature, these films are difficult to characterize by conventional techniques. ZrO2 coatings were deposited on near equiatomic Ni-Ti wires by pulse electrodeposition. Part of the samples was electrolytically polished before the coating process. The coated samples were then analyzed by ToF-SIMS to evaluate the influence of the deposition time and previous surface electropolishing on the structure of the deposited coating. The results indicate that thicker coatings were produced on the electropolished samples, in comparison with the as-received ones. The best uniformity in thickness was achieved when Ni-Ti samples were previously electropolished followed by ZrO2 electrodeposition for 1200 seconds. Moreover, it was possible to observe by this technique that the inclusions in the Ni-Ti matrix were not entirely covered by the coating.

Aiming to better understand the effects of heat treatment parameters on Ferrite-Austenite phase transformation in a 2304 duplex stainless steel different thermal cycles were applied to this steel in a quenching dilatometer. The obtained microstructures were characterized by optical microscopy, transmission electron microscopy and electron backscatter diffraction. It was noticed that the austenite formation mechanism is strongly dependent on initial ferritized state. If the initial structure is completely ferritized, the nitrogen supersaturated solid solution leads to chromium nitrides precipitation and the rate of austenite nucleation decreases. For higher cooling rates, the ferrite grain boundaries control the austenite nucleation rate. The higher the ferrite grain size, the lower the final austenite fraction. If the steel is cooled from a partial ferritized state, the ferrite-austenite phase boundaries work as austenite nucleation site and the austenite growth rate is favored due to the high interfacial energy and the austenitic structures becomes coarser.