Resumo Introdução o desafio no uso do Micro-Ct tem sido estabelecer e padronizar padrões adequados para escaneamento e tratamento das imagens, para que se obtenha o máximo desempenho do equipamento, e permitir a comparação dos achados entre diferentes estudos. Objetivo o presente estudo tem como objetivo comparar a porcentagem de volume ósseo em regiões com perda óssea periodontal utilizando diferentes metodologias para definição da área a ser analisada (ROI). Material e método dez ratos foram submetidos à indução de doença periodontal, e, após a eutanásia, as mandíbulas foram escaneadas com cortes de 9 μ e 18 μm de espessura, com passo de rotação de 0.3mm. As imagens foram reconstituídas utilizando o software NRecon, e em seguida, utilizando o software CTAnalyser – CTAn, foram definidas as áreas de interesse (ROI) ao redor dos segundos molares. A primeira área de interesse (ROI1) foi definida em um padrão retangular que se restringiu às regiões interproximais e furca, onde a área total de tecido ósseo foi obtida somando os resultados dos 3 ROIs. A segunda área (ROI2) foi definida no sentido corono/apical ao redor do segundo molar até suas limitações proximais com os dentes vizinhos, onde a porcentagem de tecido ósseo pertencente às raízes foram excluídas das avaliações. As análises foram realizadas com cinco diferentes valores de thresholds (130-50, 130-60, 130-70, 130-80, 130-90 e 130-100). Resultado a análise entre os diferentes ROIs demonstrou que em ambas as análises foi observada a tendência a menor porcentagem de tecido ósseo quanto maior o contraste de tons de cinza utilizado, no entanto, nos resultados obtidos no ROI2 essa diferença não foi estatisticamente significante. Conclusão com os resultados obtidos pode se concluir que a utilização de diferentes thresholds para quantificação óssea, em áreas onde houve doença periodontal, pode trazer resultados divergentes; a definição da área de interesse interfere com os resultados obtidos e que a obtenção de uma área de interesse com a remoção das raízes mostrou-se menos susceptível à variação dos parâmetros de escaneamento.

Abstract Introduction the challenge in the use of Micro-Ct has been to establish and standardize adequate standards for scanning and image processing to obtain the maximum performance of the equipment and to allow the comparison of findings between different studies. Objective this study aims to compare the percentage of bone volume in regions with periodontal bone loss using different methodologies to define the area to be analysed (ROI). Material and method ten rats were submitted to periodontal disease induction, and, after euthanasia, the mandibles were scanned with slices of 9μ and 18μm thickness, with a rotation step of 0.3mm. The images were reconstructed using the NRecon software, and then, using the CTAnalyser - CTAn software, the areas of interest (ROI) around the second molars were defined. The first area of interest (ROI1) was defined in a rectangular pattern that was restricted to the interproximal and furcation regions, where the total area of bone tissue was obtained by adding the results of the 3 ROIs. The second area (ROI2) was defined in the coronal/apical direction around the second molar to its proximal limitations with the neighboring teeth, in which the percentage of bone tissue belonging to the roots was excluded from the evaluations. Analyses were performed with five different threshold values (130-50, 130-60, 130-70, 130-80, 130-90, and 130-100). Result the analysis between the different ROIs showed that, in both analyses, there was a tendency towards a lower percentage of bone tissue the greater the grayscale contrast used. However, in the results obtained in ROI2, this difference was not statistically significant. Conclusion with the results obtained, it can be concluded that the use of different thresholds for bone quantification, in areas where there was a periodontal disease, can bring divergent results; the definition of the area of interest interferes with the results obtained; and that obtaining an area of interest with the removal of the roots, proved to be less susceptible to the variation of the scanning parameters.

Abstract The aim of this study was to assess the influence of cyclosporine administration on the repair of critical-sized calvaria defects (CSDs) in rat calvaria filled with diverse biomaterials. Sixty animals were divided into two groups: the control (CTR) group (saline solution) and the cyclosporine (CCP) group (cyclosporine, 10 mg/kg/day). These medications were administered daily by gavage, beginning 15 days before the surgical procedure and lasting until the day the animals were euthanized. A CSD (5 mm Ø) was made in the calvaria of each animal, which was allocated to one of 3 subgroups, according to the biomaterial used to fill the defect: coagulum (COA), deproteinized bovine bone (DBB), or biphasic calcium phosphate ceramics of hydroxyapatite and β-phosphate tricalcium (HA/TCP). Euthanasia of the animals was performed 15 and 60 days after the surgical procedure (n = 5 animals/period/subgroup). Bone repair (formation) assessment was performed through microtomography and histometry, while the analyses of the expression of the BMP2, Osteocalcin, and TGFβ1 proteins were performed using immunohistochemistry. The CSDs not filled with biomaterials demonstrated lower bone formation in the CCP group. At 15 days, less bone formation was observed in the CSDs filled with DBB, a smaller volume of mineralized tissue was observed in the CSDs filled with HA/TCP, and the expression levels of BMP2 and osteocalcin were lower in the CCP group compared to the CTR group. The use of cyclosporine impaired bone repair in CSD, and this effect can be partially explained by the suppression of BMP2 and osteocalcin expression.

Resumo Introdução A quantidade e qualidade óssea na implantodontia é um fator de alta relevância quando se tem por objetivo instalar implantes e reabilitar pacientes. No entanto, essa disponibilidade é comprometida na maioria dos casos, havendo a necessidade da busca de novos biomateriais, membranas e substâncias para uma regeneração mais favorável. Objetivo: O objetivo deste estudo foi avaliar a resposta da neoformação óssea em defeitos críticos em calvárias de ratos utilizando scaffolds de fibras de blenda polimérica a partir de poli (ácido láctico-co-glicólico) e poli-isopreno (Cellprene®). O projeto foi aprovado pelo Comitê de Ética em Experimentação Animal. Material e método Neste estudo, foram utilizados 36 ratos (Rattus Norvegicus), variação albinus, Holtzman, adultos. Os animais foram submetidos à tricotomia na região da calota craniana e à confecção de defeitos ósseos circulares bilaterais com 5 mm de diâmetro. Os animais foram divididos em três grupos: GC – defeito sem colocação de biomaterial; GCol – scaffolds de colágeno (Bio-Gide, da empresa Geistlich Pharma Ag – Biomaterials); GPoli – scaffolds de fibras de blenda polimérica a partir de poli (ácido láctico-co-glicólico - Cellprene®). Cada grupo foi avaliado em quatro períodos experimentais (7, 15, 30 e 60 dias). Após esses períodos, os animais foram sacrificados, e as peças passaram por tramitação laboratorial de rotina e inclusão em parafina. Foram obtidos cortes semisseriados e corados pela técnica de hematoxilina e eosina para análise histométrica e histológica. Foi executada análise histométrica para avaliar a composição do tecido ósseo reparado (% osso). Os dados obtidos foram analisados estatisticamente com nível de significância de 95%. Resultado Foi verificado que o GCol apresentou maior preenchimento do defeito nos períodos de 30 e 60 dias em comparação aos GC e GPoli. Conclusão Os scaffolds de fibras de blenda polimérica a partir de poli (ácido láctico-co-glicólico) e poli-isopreno (Cellprene®) não apresentaram vantagens quando utilizados em defeitos críticos.

Abstract Introduction The bone quantity and quality in implant dentistry is a highly relevant factor when it aims the use of implants and rehabilitation in patients. However, this availability is compromised in most cases, with the need to research new biomaterials, membranes and substances for more favorable regeneration. Objective: The aim of this study was to evaluate the response of bone neoformation in critical defects in rat calvaries using polymeric blend fiber scaffolds from Poly (Lactic-Co-Glycolic Acid) and Polyisoprene (Cellprene®). The project was approved by the Animal Experimentation Ethics Committee. Material and method In this study 36 rats (Rattus Norvegicus), variation albinus, Holtzman, adults were used. The animals had trichotomy in the region of the skull and the confection of bilateral circular bone defects with a diameter of 5 mm. The animals were divided into 3 groups: Group GC - defect without biomaterial placement, Group GCol - collagen scaffolds (Bio-Gide, from Geistlich Pharma Ag - Biomaterials), Group GPoli - polymeric blend fiber scaffolds from Poly (Lactic-Co-Glycolic Acid)-Polyisoprene. Each group was evaluated in 4 experimental periods (7, 15, 30 and 60 days). After these periods the animals were sacrificed and the pieces underwent routine laboratory procedures and paraffin embedding. Semi-serial sections were obtained and stained by hematoxylin and eosin technique for histometric and histological analysis. Histometric analysis was performed to evaluate the composition of repaired bone tissue (% Bone). The data obtained were statistically analyzed with a significance level of 95%. Result It was found that the GCol group presented greater defect filling in the 30 and 60 days periods compared to the GC and GPoli groups. Conclusion Polymer blend fiber scaffolds from Poly (Lactic-Co-Glycolic Acid) and Polyisoprene (Cellprene®) did not have advantages when used in critical defects.