This paper describes the evaluation of the total concentration of Ba, Bi, Ca, Cd, Co, Cr, Cu, Fe, K, Mn, Pb e Zn and the bioaccessible fraction of Ba, Cu, Fe, Mn, Pb and Zn in samples of grape skins from different cultivars (Vitis Viníferas Tannat and Cabernet Sauvignon) by MIP OES. For the determination of total concentration, acid decomposition with a reflux system adapted to the digestion tubes in the oxidizing medium of HNO3 and H2O2 were used. The accuracy of the method was verified by recovery tests, whose values ranged from 80 to 120%, as well as through a comparative method in closed system. Bi, Cd and Cr showed values for total content below the LOD or below the values acceptable for health while Pb is higher than 0.2 mg kg-1, for both cultivars. To evaluate the bioacessible fraction, the gastrointestinal system was simulated using an in vitro procedure, and its performance was assessed considering the bioaccessible fraction (supernatant) and the non-bioaccessible fraction, whose sum should be closed to the total concentration, and the results obtained were between 81 and 120%. Both cultivars showed similar values for the bioaccessible fractions (~13.5 – 53% of the total content).

This paper describes the evaluation of a new method of sample preparation using a cold finger system with continuous water flow for rice analysis by flame atomic absorption spectrometry. The limits of detection for Cu, Fe, Mn and Zn for the proposed method were 0.36, 1.84, 2.12 and 0.16 mg kg-1, respectively. The RSDs were lower than 6.0% for all elements and the CRM analyzed showed values with 95% agreement. The proposed method is simple and safe for the proposed objective and does not require the use of mixtures of acid or special equipment for sample preparation.

This paper describes the development of methods in micro-scale for the determination of K, Mg, Na and Zn in meat by atomic spectrometry techniques. The limits of detection (LOD) for K and Na by microdigestion were 0.18 and 0.20 mg g-1, respectively whereas LOD for Mg and Zn by microsolubilization with TMAH were 2.40 and 18.4 µg g-1, respectively. The RSD values were lower than 6.0% and the CRMs analyzed showed values with 95% agreement. The proposed methods are simple, fast and use small amounts of sample (around 10 mg) yet do not require special equipment for sample preparation.