An analytical method for the determination of Al, Ca, Cd, Cr, Cu, Fe, Hg, K, Mg, Na and Zn in breast of conventional, country and Christmas chicken and turkey samples using microwave induced plasma optical emission spectrometry (MIP-OES) technique was developed. Samples were decomposed in a digester block with a reflux system under conditions optimized using a central composite design as it follows: 2 g of sample, in 7.5 mL of HNO3 during 180 min at 160 °C. The accuracy was evaluated by the analysis of standard reference material SRM 1546 meat homogenate (94 to 108%) and also by addition and recovery tests (80 to 121%). The highest concentrations, in mg kg-1, of Al (2.77), Ca (88.3), Cu (1.99), Fe (3.65), K (3236), Mg (292.62) and Na (312.03) were found in the breast of conventional chicken sample. Zinc presented high value in the breast of turkey sample (10.6 mg kg-1). However, the found concentrations were lower than the daily consumption limit established by supervisory agencies and reference limits from Brazilian legislation. Cadmium, Cr and Hg presented values below limit of quantification. In this way, it is evident that chicken breast should be consumed in a complementary way in a healthy diet.

The objective of this study was to evaluate the concentration of Cu, Zn, Cr and Pb in different species of fish collected in the estuarine and limnic regions of the São Gonçalo channel, located in the Patos-Mirim lagoon complex in the coastal plain of Rio Grande do Sul State (Southern Brazil) during 2013 (autumn, winter and spring) and 2014 (summer). Fish samples were decomposed in a digester block with a reflux system under conditions optimized using a central composite design as it follows: 250 mg of fish sample, 5 mL HNO3, 2 mL H2O2 during 2 h at 150 °C. The concentrations obtained ranged from 6.7 to 12.0 mg kg -1 for Cu; 1.8 to 23.6 mg kg -1 for Zn; 37 to 487 µg kg -1 for Pb; and 40 to 1268 µg kg -1 for Cr. The highest concentrations of Cu, Zn and Pb, were observed in fishes collected at locations in the estuarine region and Cr showed high levels, especially in the limnic region. The samples of the species Loricariichthys anus (viola) showed the highest concentrations of all analytes investigated.

This paper presents a study involving the development of a new mini polytetrafluoroethylene (PTFE) vessel project for biological sample preparation in micro scale in closed system with microwave radiation for subsequent determination of Cd, K, Mg and Na by atomic spectrometry techniques. All experiments were carried out in micro quantities of samples (up to 20 mg) and reagents (300 µL of HNO3) for 5 min at 350 W. Certified reference materials of biological samples (bovine muscle and liver) were used to evaluate the accuracy of the proposed system and the results obtained were in agreement with the certified value at 95% of confidence (t -test). Relative standard deviations (RSD) were lower than 8.0% for all elements. The proposed method is not only easy and fast, but it is also based on the use of an inexpensive system for sample digestion.

This paper describes the optimization of a sample preparation method using response surface methodology for Al, Cd, Cu, Fe, Mg, Mn, Mo, Na, Ni and Ti determinations in samples of rice husk and rice husk ash by MIP OES. Sample preparation was performed using a reflux system adapted to the digestion tubes. This system allowed the decomposition of the samples without the necessity of replacement of the acids during this step without any loss of volatile elements. The decompositions were performed with 3.6 mL of HNO3 and 1.4 mL of H2SO4 for 205 min in a digester block at 225 ºC. The detection limit for determination of respective analytes in both samples were satisfactory. The RSDs for the analytes were less than 10%. Moreover, the accuracy of the method can be verified by recovery tests, whose values ranged from 82 to 115% for husk samples and 82 to 120% for ashes. The proposed method was presented as a simple, safe and low cost procedure being suitable for sample preparation and subsequent determination of metals by MIP OES.

In this work, two sample preparation procedures for subsequent determination of Na, K, Ca and Mg by techniques of atomic spectrometry in samples of Brazilian cream cheese were evaluated. The determinations were performed on two equipments, F AAS and MIP OES, which presented similar results, being evident the advantages of MIP OES since it is a multielementar technique with low operational cost and high efficiency. The first procedure was carried out by acidic decomposition (HNO3/H2SO4) in a reflux system, and the second used the alkaline solubilization with tetramethylammonium hydroxide. The accuracy was verified by recovery tests and the results were between 80 and 104% for both procedures. A comparison with a reference procedure was also performed and no significant differences have been observed at the 95% confidence level. The evaluated elements were not in accordance with the values indicated on the labels of all products, showing the importance for monitoring these products. The methods of sample preparation proposed showed to be simple, inexpensive, providing accurate and precise results, and are a promising alternative to be used for the quality control of these routine test samples.

This paper describes the method optimization using response surface methodology for Cu, Fe, Zn and Na determinations in coal and ash samples by spectrometry techniques. The sample preparation was performed using a recirculation system adapted in the digestion tubes. This system allowed increase of temperature in the digester block above the boiling point of the reaction medium, avoiding acid evaporation during the heating. The digestions were realized with HNO3 and H2O2 for 1 h in a digester block at 145 °C. The limits of detection for determination of Cu, Fe, Zn and Na in both samples were satisfactory. The RSD for the analytes were lower than 6.0%. Statistical tests showed that results for all analytes do not vary significantly with official method (ASTM), considering a confidence limit of 95%. Besides, the accuracy was verified by recovery tests, whose values ranged from 92.7 to 104.7% in coal, and 98.7 to 115.3% in ash.