Abstract In this paper we report the effect of alloying elements on hydrogen storage properties of melt-spun Mg-based alloys. The base alloys Mg90Si10, Mg90Cu10, Mg65Cu35 (at%) were studied. We also investigated the effect of rare earths (using MM: mischmetal) and Al in Mg65Cu25Al10, Mg65Cu25MM10 and Mg65Cu10Al15MM10 alloys. All the melt-spun alloys without MM show a crystalline structure, and the Mg65Cu25MM10 and Mg65Cu10Al15MM10 alloys showed an amorphous and partially amorphous structure respectively. At 350˚C all the alloys had a crystalline structure during the hydrogen absorption-desorption tests. It was observed that Si and Cu in the binaries alloys hindered completely the activation of the hydrogen absorption. The partial substitution of Cu by MM or Al allowed activation. The combined substitution of Cu by MM and Al showed the best results with the fastest absorption and desorption kinetics, which suggests that this combination can be used for new Mg-alloys to improve hydrogen storage properties.

Dehydrogenation of a BCC alloy of composition 52Ti-12V-36Cr doped with 4 wt.% Zr7Ni10 was studied by diffraction using synchrotron and neutron radiations. In the case of synchrotron radiation dehydrogenation was imposed by raising the temperature while keeping the sample under vacuum. We found that prior to final dehydrogenation the FCC dihydride phase is becoming metastable. Neutron in-situ experiment was done by keeping the deuterided sample at 200°C and slowly reducing the pressure. This lead to a reduction of the occupation factor of deuterium in the FCC phase and an increase of the isotropic atomic temperature factor of deuterium.

In this paper we address some aspects of the kinetics of hydrogen absorption and desorption of Mg2FeH6 nanocomposite powder. The Mg2FeH6 material was prepared from a 2Mg-Fe composition by reactive milling under H2 pressure at room temperature. After mechano-chemical processing, the material was mainly constituted of Mg2FeH6 having a hydrogen gravimetric capacity corresponding to 94% of the theoretical capacity. The kinetics of hydrogen absorption at constant temperature and the transformation of phases during this process were studied. The kinetics of hydrogen absorption presented a two-step behaviour. First, β-MgH2 was formed with faster kinetics than Mg2FeH6 under constant temperature and H2 pressure. Then, β-MgH2 reacted with α-Fe forming Mg2FeH6 in a much slower reaction. Unexpectedly, reaction of hydrogen desorption showed an one-step kinetics, even if Mg2FeH6 and β-MgH2 phases were previously present in the powder.

Severe plastic deformation routes (SPD) have been shown to be attractive for short time preparation of magnesium alloys for hydrogen storage, generating refined microstructures and interesting hydrogen storage properties when compared to the same materials processed by high-energy ball milling (HEBM), but with the benefit of higher air resistance. In this study, we present results of a new processing route for Mg alloys for hydrogen storage: rapid solidification followed by cold work. A Mg97Ni3 alloy was processed by melt spinning (MS) and by extensive cold rolling (CR). Submitting Mg97Ni3 ribbons between steel plates to cold rolling has shown to be a viable procedure, producing a thin cold welded foil, with little material waste. The as-processed material presents a high level of [002] fiber texture, a sub microcrystalline grain structure with a high density of defects, and also a fine dispersion of Mg2Ni nanoparticles. This refined microstructure allied to the developed texture resulted in enhanced activation and H-sorption kinetics properties.