ABSTRACT: Thoracoscopy is replacing open lung biopsies because it is less invasive, usually the technique is done using three portals and intracorporeal suture technique. This study described the feasibility and efficacy of a novel pre tied loop ligature and to propose a thoracoscopic access strategy with two portals to perform lung biopsy in patients under 5 kg. Ten rabbits were positioned in dorsal recumbency. Total thoracoscopic lung biopsy was performed using a combined transdiaphragmatic approach and a right intercostal approach. A pre tied loop ligature was placed to perform a caudal lung lobe biopsy. Insufflation of the thoracic cavity was not performed. The total surgery time was 41.4 ± 14.5 min. The procedure was carried out free of complications that prevented slippage or tightening the knot or that made it come loose after the lung biopsy; there was no serious complication during the surgical procedure. The samples obtained averaged 1x0.64x0.45 cm (Length, Width, Depth) and were considered satisfactory according to the histopathologic evaluation. Thorax radiographs taken before and after the surgeries were compared and showed no pneumothorax or hemothorax. Necropsy confirmed no knot failure occurred at the biopsy site. The use of the novel pre tied loop ligature is a safe and effective technique, avoiding problems with the limited size of the thoracic cavity in small patients.

RESUMO: A toracoscopia está substituindo as biópsias pulmonares abertas por ser menos invasiva. Usualmente a técnica é feita utilizando três portais e ligaduras feitas intra corporalmente. O objetivo deste estudo foi descrever a viabilidade e eficácia de uma nova ligadura com alça pré-amarrada e propor uma estratégia de acesso toracoscópico com dois portais para realizar biópsia pulmonar em pacientes com menos de 5kg. Dez coelhos foram posicionados em decúbito dorsal. A biópsia pulmonar por toracoscopia total foi feita pela abordagem combinada transdiafragmática e abordagem intercostal direita. Uma nova ligadura pré-amarrada foi colocada para realizar uma biópsia do lobo pulmonar caudal. Não foi realizada insuflação da cavidade torácica. O tempo total de cirurgia foi de 41,4 ± 14,5 min. Os procedimentos foram realizados sem complicações que impedissem o escorregamento ou aperto do nó ou que o soltassem após a biópsia pulmonar; não houve nenhuma intercorrência grave durante o procedimento cirúrgico. As amostras coletadas tinham tamanho médio 1x0,64x0,45 cm e foram consideradas satisfatórias de acordo com a avaliação histopatológica. As radiografias de tórax feitas antes e depois das cirurgias foram comparadas e não mostraram pneumotórax ou hemotórax. A necropsia confirmou que não ocorreu falha do nó no local da biópsia. Conclui-se que uso da nova ligadura com alça pré-amarrada é uma técnica segura e eficaz, evitando problemas com o tamanho limitado da cavidade torácica em pacientes pequenos.

ABSTRACT Purpose: This study compared, through biomechanical evaluation under ventral flexion load, four surgical techniques for ventral stabilization of the atlantoaxial joint in dogs. Methods: In total, 28 identical atlantoaxial joint models were created by digital printing from computed tomography images of a dog, and the specimens were divided into four groups of seven. In each group, a different technique for ventral stabilization of the atlantoaxial joint was performed: transarticular lag screws, polyaxial screws, multiple screws and bone cement (polymethylmethacrylate–PMMA), and atlantoaxial plate. After the stabilization technique, biomechanical evaluation was performed under ventral flexion load, both with a predefined constant load and with a gradually increasing load until stabilization failure. Results: All specimens, regardless of stabilization technique, were able to support the predefined load without failing. However, the PMMA method provided significant more rigidity (p ≤ 0.05) and also best resisted the gradual increase in load, supporting a significantly higher maximum force (p ≤ 0.05). There was no statistical difference in flexural strength between the transarticular lag screws and plate groups. The polyaxial screws method was significantly less resistant to loading (p ≤ 0.05) than the other groups. Conclusions: The PMMA technique had biomechanical advantages in ventral atlantoaxial stabilization over the other evaluated methods.

Abstract Purpose: To evaluate clinically dogs that underwent tibial tuberosity advancement (TTA) six months previously. Methods: Dogs of various breeds, gender, weight, and age that had CCL rupture and underwent TTA for treatment were included in this study. Parapatellar arthrotomy was performed in all patients to assess the joint for a ruptured ligament and meniscal injury before the TTA. The appropriate cage for the TTA was chosen with planning surgery. The surgical procedure was performed according to the literature, using a modified Maquet technique. Six months after surgery, lameness during walking; muscular atrophy; crepitation, cranial drawer and tibial compression tests and quality of life based on owner’s evaluation were assessed. Results: Postoperative complications were observed in only one knee (4.76%), with a surgical site seroma. The mean lameness score at walking was 0.29 (± 0.64). The mean score regarding muscular atrophy was 0.95 (± 1.56). The mean score of the cranial drawer test, in a range from 0 to 5, was 1.52 (± 1.54). The owners rated the dog’s quality of life as excellent in 44%, good in 30%, and moderate in 17%. Conclusion: This clinical study supports the affirmation that patients who undergo TTA for treatment of CCL rupture have an acceptable response.