ABSTRACT ABS resins have wide application in the market, mainly in the manufacture of household appliances, telephones, automotive industry and others, and need to be processed by extrusion for the manufacture of products. The variables used in the process of extrusion of polymers have a direct influence on their mechanical properties. The objective of this study was to evaluate the different speeds of the extruder screw (15, 30, 45 and 60 rpm) on the mechanical properties of raw ABS after the extrusion process. Izod impact resistance and tensile tests, were also performed. The fractures of the samples tested by Izod impact were observed via optical microscopy, scanning electronic microscopy (SEM), and roughness was measured. Calorimetric tests (DSC) and thermogravimetry (TGA), as well as melt flow index (MFI), were also performed. The most significant results were observed for the extruder screw speed of 60 rpm. For the impact test, a reduction in impact energy of approximately 3% was observed, with the same result for tensile resistance. However, an increase in the value of the elastic modulus and the MFI was observed due to the increase in the degree of crystallinity, which was caused by the higher shear of the polymer mass in the screw of the extrusion equipment. Additionally, an atypical case occurred for the ABS polymer in the highest rotation, since it was the polymer that suffered the greatest shear in the polymer chains due to the degradation of the butadiene phase. market appliances telephones others products 15, 15 (15 30 4 6 rpm performed SEM, SEM , (SEM) measured DSC (DSC TGA, TGA (TGA) MFI, (MFI) test 3 However crystallinity equipment Additionally rotation phase 1 (1 (SEM (TGA (MFI (

Abstract Solid residues from agroindustry often accumulate and cause environmental imbalance. An alternative to this is to use this residue as a reinforcement in polymers. The achievement of this work was to characterize a composite with a polystyrene matrix reinforced with Brazil nut shells residues. The residues were cleaned and ground to then produce the samples via injection molding with the proportions of 0%, 2.5% and 5% of load. The specimens were characterized using mechanical tensile testing and thermogravimetric analysis (TGA). The mechanical test showed that the composite with 2.5% of filler had greater stiffness and strength was improved by 5%. Thermal analysis showed an increase in the temperature for the beginning of the degradation of the M2.5 composite. The results confirm a potential application in the automotive industry for the polystyrene composite reinforced with Brazil nut shells. imbalance polymers 0 0% 25 2 5 2.5 load TGA. TGA . (TGA) M25 M M2 M2. 2. (TGA

Abstract The properties of aluminum alloys can be improved by the processing conditions that cause changes in the microstructure and by the addition of alloy elements. In order to understand the physical behavior and mechanical properties of aluminum alloys, it is important to be aware of some of the microstructural characteristics. Some of these characteristics are the morphology, alloy elements, volume and size, and second phase. In this study, we analyzed the effect of annealing on the mechanical and microstructural properties of the laminated AA 5182 aluminum alloy, when subjected to different annealing conditions. The alloy was heated to temperatures of 50º C, 100º C, 150º C, 200º C, 250º C and 300º C for 10 minutes and left to cool naturally. The evolution of the microstructure was characterized by optical and electronic microscopy with EDS, and, to obtain the mechanical properties, a tensile test was performed and the fractures were subsequently analyzed. The results showed that the heat treatment used reduced the amount of second phase particles and this influenced the mechanical properties.