Abstract A previous constitutive modeling for single-phase steels is extended using the mixing law to predict the behavior of hot deformation in the dual phase ferritic-austenitic intercritical zone of Fe-C-Mn-Si alloys. Mixing law considers two phases instead one, so one phase formula was modified. The constant’s values used represents average values to the same conditions in austenitic and ferritic model. The amount of each phase is determined as function of temperature and chemical composition. The developed constitutive modeling is validated by comparing the theoretical stress-strain curves with experimental isothermal uniaxial compression tests of 1008 and 1035 carbon steels at different temperatures and strain rates. The compression tests were carried out in a dilatometer with the compression load at strain rate of 10-3, 10-2 and 10-1 s-1. A good agreement was obtained between the calculated and experimental results over different stages of deformation and hardening. Microstructural analysis was also carried out to relate the deformation results to the microstructure of the steels. Finally, a general constitutive equation has been proposed for hot deformation of steels in the intercritical zone.

The combined processes; rapid solidification, addition of Cu3P compound and heat treatments to improve the mechanical properties of the hypereutectic Al-13Si, Al-20Si and Al-20Si-1.5Fe-0.7Mn alloys (in wt. %) was studied. Optical microscopy and scanning electron microscopy were used to characterize the microstructures. The mechanical properties were evaluated by tensile tests. It was found that the cooling rate (20-50°C/s) used to solidify the alloys plus the addition of Cu3P compound favored the formation of fine primary Si and the transformation of the Al/Si eutectic from acicular to semi-transformed morphology. The spheroidization of the Al/Si eutectic after heat treatment caused an increase in the elongation (%) compared with the as-cast alloys. Al-13Si alloy showed the highest UTS and elongation (%) values, reaching values up to 215 MPa and 9.6%, respectively. On the other hand, the Al-20Si-1.5Fe-0.7Mn alloy showed the lowest UTS (180MPa) and elongation (3.4%) values. The formation of the Fe-intermetallic compounds caused a negative effect on the mechanical properties of the Al-20Si-1.5Fe-0.7Mn alloy.